|
Search:
Type: Posts; User: do it again
Search:
Search took 0.00 seconds.
-
Hi, find the thread titled -unusual 4 bbl intake- under my user name, scroll down to find a list of intakes with their ratings that was posted by Big Bad AMX. It should help you decide. :rolleyes:
-
Can anyone tell me what oil to put in the amc 20 with the twin grip differential ? :rolleyes:
-
:p Okay I found in the 73 service manual that my 304 with 3 speed combo meant a 3:54 gearing.I also found that the limited slip has a smaller rectangle housing,(easy to I.D.).Now I am wondering if my...
-
:D Hi,
I recently put a used rear end in my 74 javelin from a javelin built to drag race. Someone built it with moser axles and it is supposed to be limited slip and has a four link set up welded...
-
Hi, I live near you in Mcminnville. I sometimes drive through Clarksville and would like to see your car sometime. I have a 74 AMX clone that I am finishing. anci@blomand.net
-
:eek: I recently read a wiring diagram for a 69 AMX. I am wondering if the 74 Javelin wiring is similar. I am trying to figure out what the loose pink wire below my voltage regulator is for.It comes...
-
:cool:
Hi Guys,
I haven't been logged in for a while so I may have missed it, Does anyone know of any AMC meets this summer near Tennessee? Last year I attended the AMO meet in Huntsville Alabama....
-
Will 1972 360 heads fit a 1974 304 ? :confused:
-
-
Can anyone tell me the application of a borg 3 speed with casting #wg div t96j?
-
:confused: Where can an interested AMC fan find a reference that will list engine casting numbers? I'd like one that covers all parts;heads,intakes ,etc.and includes all years through the 60's and...
-
Thanks Big Bad , awesome reference!
-
I understand what you were saying now.This car will be a near stock driver and I want all of my low end torque, no 7000 rpm runs for me.Thanks 304.
-
Yes I have dual exhaust.What did you mean dont use if my build up is a little better than stock? Dont use the torker?
-
:confused: I have seen a 4 bbl AMC intake that has individual volcano shaped carb mounting surfaces instead of a large single flat surface.What is the application for this intake ,is it a later...
-
:) The quote they gave me was $125.00,around $ 10.00 shipping in the middle Tn area U.S. :D
-
O.K.,on a 71 to74 Javelin ,in the rear quarter section, behind the rear wheel,below the crease ,is the curve supposed to flow all the way to the bottom or is it supposed to have a slight flat...
-
thanks donsjave! im still looking
-
hey guys thanks for previous help on my 74 jav.i can not find a kit for a black vinyl top.am i out of luck?i want oem type,HELP!
-
can anyone tell me if the block to bellhousing pattern is the same on a 304 and a 360?i found a 83 360 2-barrel, will it fit my 304 t15 trans? does anyone know horsepower rating on the 83 360 2...
-
what is good to juice up a stock 304?
-
i have a stock 304 in my 74 javelin.im going to build it. i think i want 300 horse.i want to keep most everything else near stock.suggest? would a performer intake and 4 bbl with a hot cam and 030....
| |