|
-
Difficult time cutting rivets... Help!
Ok, this is going to sound corny, but I am having a tough time cutting the ball joint rivets so I can replace them.
I remember cutting them with a chissel in the past, but the chissel I have seems to stretch and elongate them badly.
Yes my chissel is new... is there a type of cutting head that works best?
-
Ok, I am done! I went a head and forged through cutting the heads off with my chissel. Just thought that the heads would pop off easier than they did.
Note: Wack away like there is no tomorrow, eventually they'll break or your tool will!
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
| |