 |
-
Fri Apr 08, 2005, 01:11 PM
#1
Gas tank help needed
Hi all, I removed the gas tank from my 74 Javelin and wasn't able to trace where the float wires were hooked on to the tank. I'm ready to re-install the tank but I have two wires danging down from the frame. One is green and one is white. I figure the green attaches directly to the stud sticking out of the float unit. I can't see anywhere that the white wire would connect to. There is no terminal to plug into or any screws to attach it to. Can anyone give me a hand?
-
Tue Apr 12, 2005, 06:56 PM
#2
Moderator
The green wire goes to the main stud on the sender. The white wire should be about 6" long or so and it is a ground. The white wire is soldered to the sending unit main plate and has an eyelet on the other end which connects to the frame with a single sheet metal screw.
.
Similar Threads
-
By Charger490 in forum Restoration Q & A
Replies: 2
Last Post: Sun May 22, 2016, 04:57 PM
-
By Centerline6 in forum Restoration Q & A
Replies: 1
Last Post: Sun May 22, 2016, 04:48 PM
-
By amxrestomod in forum Body, Glass and Interior
Replies: 3
Last Post: Mon Dec 29, 2008, 05:41 PM
-
By fitz11 in forum General and Misc.
Replies: 3
Last Post: Fri Apr 07, 2006, 06:57 PM
-
By Rockpointe_kidz in forum General Discussions
Replies: 0
Last Post: Fri Apr 08, 2005, 01:11 PM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|  |