Results 1 to 4 of 4

Threaded View

  1. #1

    Default Need some advice

    I have a 79 Concord Wagon with the 258 2v auto, front disk and rear drums.
    Here is my story. I took a look at the rear shoes and noticed I ought to
    replace the shoes before the rivits dug into the drums. I bought rebuilt
    shoes from Advance Auto Parts. The next weekend I replaced the shoes. I
    did one side at a time so I could look at the side I had not touched yet for
    locations of springs just in case I forgot. I've done this for years replacing
    rear shoes. I did NOT have the drums turned because there was no damage
    to them from what I could see. By the way, there is 75k miles on the 79 so
    this was the first time shoes were replaced. Everything went back together
    like clock work. I adjusted the new shoes to where they touched the drums
    then backed them off a bit.

    Here is the problem. I took the car for a test drive. I was going around 50
    mph and applied the brakes kinda hard. The rear of the car vibrates bad
    untill I let off the brakes or get to around 25 mph.

    I then thought maybe the drums do need turned so I removed them and took
    them to have them turned. I had them check both drums first to make sure
    they still could be turned plus are they out of round. Both drums have never
    been turned and both were not out of round. They did turn both drums as I
    waited and watched.

    I re-installed both drums and took the car for another test drive. Same thing.
    Vibrates when brakes applied untill around 25 mph.

    What I ended up doing (for now) was I backed the rear shoes off even more
    to where they hardly do any braking at all. No more vibrating and the brakes
    are doing their job. I can lock up the rear wheels if I want to (tested it).

    So guys, what the heck did I do wrong with this simple brake job?
    I grew up replacing shoes both front and rear and never ran into this
    problem before. It's hard to believe I might have had the shoes adjusted
    too tight, or did I? The old (still serviceable) shoes on the car worked just
    fine and no vibration or problems at all. I just wanted to replace them before
    the rivits hit the drums.

    You can leave a reply here or E-Mail at. n8fis@juno.com

    Thanks for any and all replys. Bill in Ohio
    Last edited by RadioMan; 10-30-2004 at 01:12 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •