I am looking at the wiring diagram for my 68 (working on the fuel guage circuit)
and see where the wires from the back of the car seem to go to a terminal strip before they get to the dash connector plug. Does anyone know the location of this strip so I can check continuity for the yellow line to the sender before I remove the dash? Thanks for any help.
On another note....I looked for an AMC in the local junkyard so I could make the brake conversion to a less expensive disk setup but there were none to be found...not ! AMC. So I sucked it up and the local Corvette guy had just rebuilt a set of 4 piston calipers, stainless lined, 175 each. The shim setup took a while but they went on and seem to work ok with the car on jackstands. I only have one more weekend to work on the car to get it to Hot August Nights.
Anyhow, as always, any help is greatly appreciated,
blurat