 |
-
Mon May 29, 2006, 01:26 PM
#1
Junior Member
Backup light
Can anyone tell me where the 2 brown wires from the backup lights connect on the t10 transmission? Got a diagram but can't find it on the tranny...
-
Sun Jun 11, 2006, 12:08 AM
#2
amc stock manual linkage on my 69 i had years back had a plunger switch that mounted to the linkage housing that bolted to the trans if my memory isnt too faded
-
Mon Jun 19, 2006, 10:43 PM
#3
Senior Member
Back up switch for 4 speeds
The AMX and Javelins used a plunger switch that was located on the 4 speed linkage. The exact location is where the reverse rod is located there should be a hole in the shifter housing and when you throw into reverse it will engage a plunger switch.
To replace these switches can be an expensive proposition in that the after market guys are getting about $85-95 for them. The AMX we have doesn't have one there anymore and the wires are taped up until I can find a replacement for it that doesn't cost so much.
Similar Threads
-
By CloudyB in forum Electrical and Accessories
Replies: 7
Last Post: Mon Mar 26, 2007, 03:29 AM
-
By trevorkoback in forum Electrical and Accessories
Replies: 2
Last Post: Fri Mar 16, 2007, 03:41 PM
-
By barebull98 in forum Electrical and Accessories
Replies: 0
Last Post: Fri Mar 24, 2006, 02:02 AM
-
By Mr. Ellas in forum Restoration Q & A
Replies: 1
Last Post: Wed May 18, 2005, 05:39 PM
-
By CFChris in forum Electrical and Accessories
Replies: 4
Last Post: Fri Feb 18, 2005, 02:52 AM
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
|  |